Engineering case

All raw materials are imported from Japan SUS314, heat-resistant 1250 ℃, strong anti-oxidation and anti-carburizing.

Introduction of fault prone to conveyor belt

Release time:

2022-08-02


ConveyingMesh beltWhat are the easy failures?

The conveyor belt is a conveyor line for washing, drying, cooling and heat treatment. The main raw materials are A3 low carbon steel, 45# steel, 1Cr13 heat-resistant steel, stainless steel, 304 stainless steel, 1Cr18Ni9Ti stainless steel, 0cr18ni14no2cu2 heat-resistant acid-resistant steel, etc. The conveyor belt is generally divided into ordinary type, enhanced type, balanced type, combination balance type, herringbone type, double balanced type, chain drive belt, B type mesh belt, etc. through a special mold. The mesh width is 200mm-3500mm. Usually, this wheel is used for positioning and transmission. Widely used in electronic professional circuit board curing, solid solution, drying, cover industry dripping glue drying, food industry chocolate, biscuits, fish baking, quick freezing, drilling, etc. The edge of B- type mesh belt can be driven by chain.
  
1. If the mesh belt deviates, adjust the tension shaft at one end of the driven shaft and adjust it step by step. Note that too fast adjustment will cause scratches on the edge of the mesh belt.
  
2. The mesh belt shakes, check whether the pallets and rollers in the conveying channel are rusty and refuse to rotate, and adjust them one by one.
  
3. If the chain drive mesh belt jumps and runs unstable, check whether the sprockets at both ends of the driving shaft are synchronized and whether the tooth ends are excessively worn.

The above contents are providedMesh beltFactory finishing release, reprint please indicate!