Engineering case

All raw materials are imported from Japan SUS314, heat-resistant 1250 ℃, strong anti-oxidation and anti-carburizing.

What are the common causes of stainless steel mesh belt slipping?

Release time:

2022-01-25


Stainless SteelMesh beltWhat are the common causes of slippage?

1. The initial tension is too small. The tension at the point where the stainless steel mesh belt leaves the drum is insufficient, causing the stainless steel mesh belt to slip. This usually occurs at startup. The treatment method is to adjust the tensioning device and increase the initial tension.
  
2. The tail roller bearing is damaged and does not rotate, or the upper and lower roller bearings are damaged and do not rotate too much. The cause of the damage is that the tail of the machine is too much floating and sinking, and the damaged or inflexible rolling parts are not repaired and replaced in time, resulting in increased resistance and slippage.
  
3. The friction between the transmission drum and the stainless steel mesh belt is not enough, resulting in slippage. The reason is mostly stainless steel mesh with water or humid environment. The treatment method is to add some rosin powder in the drum.
  
4. If the load of the stainless steel mesh belt is too large, it will slip beyond the bearing capacity of the motor. The advantage of slipping at this time is to maintain the motor. Otherwise, the motor will burn out over time. But in terms of operations, it was a slip-and-fall event. To deal with the phenomenon of stainless steel mesh belt slipping, we must first find out the cause of the slip, in order to take effective measures.
  
5. Starting too fast can also cause slippage. Start slowly at this time.

The above contents are providedMesh beltFactory finishing release, reprint please indicate!