Engineering case

All raw materials are imported from Japan SUS314, heat-resistant 1250 ℃, strong anti-oxidation and anti-carburizing.

Could you tell me the mesh belt conveyor has those steps?

Release time:

2021-10-10


     Mesh beltConveyor steps have those?

1. Cover the main power switch, check whether the power supply of the equipment switch is normal and whether the indicator light is on. After everything is normal, proceed to the actual operation of the next step.
  
2. Cover the main power switch of each control circuit and check whether everything is normal. All normal conditions are as follows: mechanical equipment does not pose, mesh belt conveyor operation indicator does not light, frequency converter and other mechanical equipment indicator light, frequency converter display information and control panel display information is normal.
  
3, according to the production process in order to start all electrical equipment. After the previous electrical equipment is started normally, start the next electrical equipment.
  
4. During the operation of the mesh belt conveyor, the requirements of the objects in the design scheme of the conveying material and the conveying capacity of the mesh belt conveyor must be strictly observed. Secondly, it should be noted that all kinds of staff shall not touch the part of the fitness exercise of the mesh belt conveyor, and laymen shall not touch the electrical components and control buttons at will. Finally, the mesh belt conveyor cannot be short-circuited with the frequency converter during operation. If the maintenance is clear, it can only be carried out when the DC inverter is stopped, otherwise the inverter may be damaged.
  
5. When the mesh belt conveyor stops running, press and hold the stop button until all system software stops, and then disconnect the main switch power supply.

The above contents are providedMesh beltFactory finishing release, reprint please indicate!