Engineering case

All raw materials are imported from Japan SUS314, heat-resistant 1250 ℃, strong anti-oxidation and anti-carburizing.

Lubrication and cleaning methods in mesh belt conveyors

Release time:

2021-07-14


     Mesh beltWhat are the lubrication and cleaning methods in the conveyor?

The mesh belt conveyor is coated with an appropriate amount of anti-rust oil when leaving the factory and packaged with anti-rust paper. As long as the packaging is not damaged, the quality of the mesh belt conveyor will be guaranteed. However, when the temperature is lower than 65% and the temperature is about 20 ℃ for a long time, it is best to store it on a shelf 30cm from the ground. In addition, the storage place of the belt conveyor should avoid direct sunlight or contact with the cold wall.
  
Since the bearings are rust-proof and packaged, do not open the package in front of the equipment. In addition, the mesh belt conveyor is coated with anti-rust oil, which has excellent stability. For general-purpose mesh belt conveyors or mesh belt conveyors filled with smooth grease, they can be used directly without cleaning. However, for belt conveyors with nets or instruments for high-speed rotation, clean cleaning oil should be used to wash away the anti-rust oil. At this time, the mesh belt conveyor is easy to rust and cannot be placed for a long time.
  
Clean the mesh belt conveyor and housing, and confirm that there are no scars or burrs left by machining. There shall be no abrasive (SiC, Al2O3, etc.) sand, chips, etc. in the shell. Secondly, check whether the size, shape and processing quality of the shaft and shell are consistent with the drawings. Before the installation of the mesh belt conveyor, the matching surface of the shaft and the casing should be coated with engine oil, and the inspection is qualified.

The above contents are providedMesh beltFactory finishing release, reprint please indicate!