Engineering case

All raw materials are imported from Japan SUS314, heat-resistant 1250 ℃, strong anti-oxidation and anti-carburizing.

Mesh belt conveyor to reduce the load of those methods?

Release time:

2021-04-27


mesh belt conveyor to reduce the load of those methods?

1. As the impact quality decreases, the driving load of the belt conveyor decreases. Given the mass of the raw material, the dynamic load can be reduced if the mass of the support roller in the impact posture is reduced.
  
2. By increasing the total number of idlers and changing the geometry of the idlers, the dynamic load of the belt conveyor can be reduced, thereby reducing the deformation quality of the idlers and the feed height-width ratio.
  
3. Buffer roller is an important method to reduce the load of belt conveyor. In addition, the elastic mold of the drive shaft splint should be much smaller than the elastic mold of the mesh belt conveyor, and the splint should have a sufficient thickness (3cm-5cm).
  
4. The diameter of the buffer idler should be expanded as much as possible without significantly increasing the net weight of the buffer idler. The upper and lower cover rubber of the conveyor belt conveying large and hard raw materials should be thicker than that of the general conveyor belt.

The above contents are providedMesh beltFactory finishing release, reprint please indicate!