Engineering case

All raw materials are imported from Japan SUS314, heat-resistant 1250 ℃, strong anti-oxidation and anti-carburizing.

Installation Guidance and Precautions of Conveyor Belt

Release time:

2021-04-21


What are the installation instructions and precautions for the mesh belt on the conveyor?

Turn off all power, remove the protective cover, loosen the mounting bolts of the motor, and then move the motor to loosen the mesh belt to remove the damaged mesh belt. If it is assumed that the removed mesh belt has abnormal wear, it means that the transmission equipment has been named, and then a suitable mesh belt has been selected for replacement.
  
First, the stainless steel mesh belt should be sorted out. At this time, it should be noted that: do not use sandpaper to wipe off oil or dirt; do not choose to soak or wash directly in detergent. Both of these methods will damage the stainless steel mesh belt.
  
Before replacement, the mesh belt should be monotonous. Check the anti-deviation of the mesh belt, the maintenance of the transmission device and the errors and wear of other maintenance equipment, and immediately adjust and repair them. Install the stainless steel mesh belt on the conveyor, then first adjust the middle distance of the transmission equipment, and then use a tension meter to test the mesh belt to a suitable tension. Then tighten all the bolts of the motor. If the bolts are tightened, the function of the conveyor belt may deteriorate.
  
After the mesh belt is replaced, the working conveyor should check the condition after replacement. Assuming noise and vibration, it should be turned off immediately to check the motor and bearings.

The above contents are providedMesh beltFactory finishing release, reprint please indicate!